User's Guide

uLory User Guide
10
- Install the downloaded driver (USB One Click Driver) after connecting uLory to USB Port of
PC
5.2 Check USB Serial Port
- Check if USB Serial Port is created as below after installing a driver
6. How to Use
Users should adjust setting of Serial (interface, communication speed, parity bits and flow
control) and LoRa (channel, Spreading Factor) for the communication between uLorys or
with other devices in LoryNet via AT command or LoryView. The default Serial setting is as
follows: Baud rate of 9600, Data Bit of 8 and Stop Bit of 1. Here, Data Bit and Stop Bit are
not subject to change.