User's Guide

tLory User Guide
11
Button
BUTTON DESCRIPTION
RST
Turn on the device with 1~6 switch on,
Press and hold for more than 3 seconds to reset the device
6.2 Operation Mode Setting
Users can change the communication setting of tLory with switch and detailed setting such
as sensing cycle via LoryView. Setting tLory via LoryView requires a device such as sLory or
uLory.
Setting via Utility (LoryView)
The utility provided along with tLory is available on http://www.sysbas.com where users can
download the date from the library of the homepage for the customer convenience. Users
can use LoryView for communication and setup, and find the detailed instructions on the
use in the LoryView Manuals.
<Setup Mode>
Users can set tLory to be awake for 1 minute under the Setup Mode because the default
time is set to 3 seconds, which are not enough to make changes to setup.
Refer to the table below for Dip Switch while the Power is OFF
DIP SW 1 DIP SW 2 DIP SW 3 DIP SW 4 DIP SW 5 DIP SW 6
STATUS ON ON ON ON ON ON
When the power is on, the device does not enter into the Sleep Mode for 1 minute,
operating at LoRa channel of 20 and with spreading factor of 9. Turning it on under the
Setup Mode, the device transmits sensing values to the destinations stored in the table.