Manualshelf

sWiFi_all_UserManual_Eng_DM v1.1.1

ManualsBrandsSystemBase ManualsInternet of Things (IoT)[SystemBase sWiFi] RS232/422/485 to WiFi, IEEE 802.11a/b/g/n, 2.4GHz/5GHz
11121314151617181920
sWiFi/all User Manual
11
6. Get Started
Check the input voltage matches 5V 1A and supply the correct voltage. sWiFi/all starts booting at power-on with
normal power supply. LED shows the operating status of the model including RDY, TXD and RXD. For detailed
information, please refer to CH.3 Product – LED menu.
To view or set up an environment of sWiFi/all, use must use sWiFiConfig utility, either directly connected to serial
port(RS232) or to the IP Address, the network address where sWiFi/all is operating.
(1) Connect sWiFi/all to RS232/USB port on the PC
With the RS232 serial communication port(COM port) installed on PC, put sWiFi/all in setup mode and perform
‘Connect to sWiFi/all’ using sWiFiConfig.
(2) Find and connect sWiFi/all to WiFi menu of PC.
To access sWiFi/all setup mode through the network, put sWiFi/all in setup mode, connect to sWiFi/all on PC via WiFi
and perform ‘Connect to sWiFi/all’ using sWiFiConfig.