User's Guide

sLory User Guide

AT+ETXL=<Length> before

entering the desired length;

For example, in order to

users firstly input AT+ ETXL

=3 and then AT+ ETXL

=31,32,33 .

AT+DMS=<Length>

0(0~116)

unit: byte

Serial data will be transmitted to

LoRa after a specific length of

data as specified is received

The priority is given in order of Length, STX or ETX and Time in case of that sLory includes

features of Time, STX, ETX, and Length in the condition for Serial data reception.

For example, if 1237890 will firstly be recognized according to the condition of Length if

1237890456 is entered with less than the 1-second-interval and the condition is set as

follows: Length=7, STXL=3, ETXL=3, STX=31,32,33, ETX=34,35,36, Time=100. If 5671237456

is entered with less than the 1-second-interval, the number 567 will be ignored being

considered as not STX because it does not satisfy the condition of Length but the second

priority condition. In other words, only the number 7 will be recognized as a result of

recognition of 123 for STX and 456 for ETX.

Setup via utility (LoryView)

The utility provided along with uLory is available on http://www.sysbas.com where users can

download the datA from the library of the homepage for the customer convenience. Users

can use LoryView for communication, reset, initialization and firmware update, and find the

detailed instructions on the use in the LoryView manual.

LoryNet is an IoT platform with virtual cable that enables smooth communication as if it

were reading and writing to file by connecting devices utilizing low power, mid-range

wireless and wired communication technologies to the internet.

As a collection of protocols, cables and equipment in the middle to deliver signals and data