User's Guide

sLory User Guide

Button Description

RST Reboot the system

6.2 Operation Mode Setting

There are two Modes for sLory: General Communication Mode and LoryNet Mode. General

Communication Mode is for the communication between PC and a device via sLory while

LoryNet Mode is used for the communication in a structure of LoryNet Packet.

Setup via command

Users can set AT Command via RS232 Port of a PC. To use Command, users need to set the Dip

Switch on the back of the product as shown below.

Set RS232 Port of a PC with a terminal program and open as shown below

Baud Rate: 9600

Data Bit: 8

Stop Bit: 1

Parity Bit: None

Switch on (Switch 1) to change to the Setup Mode

Change to the Setup Mode via AT Command and then, LED will blink fast during the process of

switching Mode

Switch off (Switch 1) to change it back to the Operation Mode after the completion of setup.