User's Guide

sLory User Guide
11
5. HOW TO CONNECT
No installation of programs on PC or communication device is needed for sLory. Just
connect sLory to PC or Serial port of communication device and power to DC-Jack port.
Then, RDY LED will blink in the interval set to 0.1 seconds under the Setup Mode and to 0.5
seconds under the Operation Mode.
* See 4.2 in the manuals for the details of LED operation
6. HOW TO USE
Users should adjust setting of Serial (interface, communication speed, parity bits and flow
control) and LoRa (channel, Spreading Factor) for the communication between sLorys or
with other devices in LoryNet via AT command or LoryView.
The default Serial setting is as follows: Baud rate of 9600, Data Bit of 8 and Stop Bit of 1.
Here, Data Bit and Stop Bit are not subject to change.
6.1 Switch Setting Table
NUMBER STATUS DESCRIPTION
1
ON Setup Mode
OFF Active Mode (Default)
2
ON RS422
OFF RS232 when Switch 2 and 3 are OFF
3
ON RS485
OFF RS232 when Switch 2 and 3 are OFF
4 - Not used