sLAN_all_UserGuide_Eng_DM v1.1.1

sWiFi/all User Manual
20
Serial Setting
In [Serial Setting], you can configure serial port environment. The [Submit] button must be clicked to save the changes you
have made. For changes to take effect, the device must be rebooted. You can do it from [Reboot] menu. If changes are not
saved, changed values will be lost when the device is turned off or rebooted.
If you did not click the [Submit] button to save the changed values, you can click the [Cancel] button to return to its previous
values.
If the Operation Mode in Operation Setting is set to “COM Redirector”, current serial settings shown on the screen is ignored,
but those set from the COM redirector in your computer will take place.
The main features are as follows:
Menu
Default
Description
Interface
RS-232
Current communication protocol for the serial port
(Options: RS-422, RS-485)
Termination
Register
Disable
Terminal resistor can be set when using RS-422 or RS485
RS-422 Multi-
Drop Mode
Master
Set the operation mode for serial communication in RS-422 Mode.
In Multi-drop mode, Set master as a master, slave as a slave.
In Point-to-point mode, Set both devices as Master.
Baud Rate
9600 bps
Current communication speed for the serial port
(Options: 150, 300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600,
115200, 230400, 460800, 921600 bps)
Data Bits
8
Current data bit set for serial the communication
(Options: 5, 6,7,8)