User Manual

SerialGate User Guide
68
Status : Check the connection status of the port and device server’s version information.
System : Perform firmware upgrade or reset, and initialization.
Verification : Verify each interface HW of device server.
Network Setup
Change the network configuration of device server.
In order to select Network Setup, press ‘ESC’ on the panel until ‘Main Menu’ comes up, and if ‘Main
Manu’ is displayed, press ‘<<’ or ‘>>’ until you see ‘Network Setup’. Then, press ‘Enter’ to change the
details.
At anytime ‘ESC’ is selected, it moves to the top menu and asks if a user wants to save the change in
Flash memory in case of a change made.
For more details about each menu, please refer to Chapter 5 “Configuration via Web” and Chapter 6
“Configuration via Telnet.”
Menu and selectable options are as follows.
Menu Option Default Description
Network line
Static IP, DCHP
Client
Static IP
<<, >> : Select option
Enter : Save the current option, and go to
the next menu.
IP Address 192.168.0.223
<<: Increase the value of the cursor
position.
>>: Move cursor to the next space.
Enter : Save the current option, and go to
the next menu.
Subnet Mask 255.255.255.0
Gateway 192.168.0.254
FTP Service Enable, Disable Enable
<<, >> : Select option
Enter : Save the current option, and go to
the next menu.
Telnet Service Enable, Disable Enable
SSH Service Enable, Disable Disable
WEB Service Enable, Disable Enable
PortView Address 0.0.0.0
<<: Increase the value of the cursor
position.
>>: Move cursor to the next space.
Enter : Save the current option, and go to
the next menu.