User Manual

SerialGate User Guide
62
If line type is DHCP, it is not editable. Instead, current
Gateway address is shown
def dns
<IP Address>
168.126.63.1 Set IP address of Domain Name Service
def portviewip
<IP address>
0.0.0.0
Configures IP of PC which Portview is installed
If IP is set to 0.0.0.0, Portview feature is disabled.
(Please refer to Portview User Manual in SerialGate
Utility & Documents CD for detailed information.)
def portviewport
<Port number>
4000 Set the socket number of a PC which Portview is installed.
def ftp
[enable/ disable]
Enable
Enable or disable FTP service.
If disabled, you cannot connect to SerialGate via FTP.
def telnet
[enable/ disable]
Enable
Enable or disable Telnet service.
If disabled, you cannot connect to SerialGate via Telnet.
def web
[enable/ disable]
Enable
Enable or disable Web service.
If disabled, you cannot connect to SerialGate via Web.
def ssh
[enable/ disable]
Disable
Enable or disable SSH service.
If enabled, you can connect to SerialGate via SSH.
def ddns
[IP Address]
203.32.117.1
If you set DDNS server IP, DDNS service will be enable.
But if you set “0.0.0.0”, this service will be disabled.
def ddnsuser
[username]
serialgate Set username to access DDNS server.
def ddnspass
[password]
99999999 Set password to access DDNS server.
def name
[SerialGate
name]
Product Name Set the name of SerialGate. (Max 32 bytes)
def snmp
[enable/ disable]
Disable
Enable or disable SNMP(Simple Network Management
Protocol)
- MIB-II(RFC 1213): System, Interface, IP, ICMP, TCP,
UDP - MIB-I (RFC 1317): Serial Interface
def v1readwrite
[enable, disable]
Disable
SNMP V1/2 Attributes can read and write by SNMP Agent.
In order to read attributes only, change the feature to
"ReadOnly.”