User Manual

SerialGate User Guide
19
 Termination Resistor Switch: Selection switch for termination resistor of RS422/485
 Reset: SerialGate reboots if this button is pressed for less than 3 seconds. If pressed
for longer than 3 seconds, SerialGate will restore factory default settings.
SerialGate-1020(W)/ALL(Left Side)
SerialGate-1020(W)/ALL LED / RESET
LED Status Meaning
RDY
(G
REEN)
Blink
Normal Operation
On
Power supplied to the device
Off
No power supplied to the device
SRL1
(Red)
Blink
Serial #1 data being transmitted
SRL2
(Red)
Blink
Serial #2 data being transmitted
WIFI(Green)
On
WIFI Link up
Off
WIFI Link down
LAN
(Right Orange)
On
100baseT connection detected & LAN data tran
sferred
Off
10baseT connection detected & LAN data trans
ferred
LAN
(Left Green)
On
Network connected
Off
Network disconnected
Blink
LAN data being transmitted
Reset Button