User Manual

SerialGate User Guide
15
 LED: Operation status of SerialGate. Next section describes the meaning of each
LED display status.
 LAN port: 8-pin RJ45 jack which is used when connecting SerialGate to networking
devices such as Ethernet card, hub, and router.
 Terminal block power connector: for connection of terminal block power cable
 Power connector: for connection of DC 12V adapter cable
 Serial: DB9 for RS232 and 5P Terminal Block for RS422/RS485
 Termination Resistor Switch: Selection switch for termination resistor of RS422/485
 Reset: SerialGate reboots if this button is pressed for less than 3 seconds. If pressed
for longer than 3 seconds, SerialGate will restore factory default settings.
SerialGate-1010(W)/ALL (Left Side)
Reset Button