User Manual

Eddy User's Guide
92
S23: Intercharacter Timeout Setting (default 0)
S23=0 : Not used
S23=1 : 1 x S26
S23=2 : 10 x S26
S23=3 : 100 x S26
S24: Maximum Number of Inquiry Result (default 15)
The maximum number of inquiry list can be controlled. This value is up to 15.
S26: Intercharacter Timeout (default 0)
This value describes time interval between characters used to separate the data from serial port. If there is no
more data coming from serial port in this value, data is sent to client.
S23=1 x S26=50 : Timeout-> 50msec
S23=2 x S26=50 : Timeout-> 500msec
S23=3 x S26=3 : Timeout-> 300msec
Inter Character Time Out
* Optimal Value(S23 x S26)
50ms
180
100ms
235
200ms
340
* When 10 bytes data are sent every intercharacter timeout, they are sent separately by 10 bytes at the optim
al value. If the intercharater timeout is set below the optimal value, the data will be put together and sent by
20, 30, 40 bytes or more.
S28: Escape Sequence Character (default 43)
The decimal number of the ASCII code of escape sequence character can be controlled. The initial value is 43,
the ASCII code of ‘+’.
S31: Page Timeout (default 20)
This is the timeout in seconds to attempt connection with the ATD command. After this timeout expires, the Ed
dy-BT will restart automatically. If this value is 0, Eddy-BT will attempt to connect without restarting
S33: Inquiry Timeout (default 30)
This is the timeout in seconds to execute inquiry scan.
S37: Supervision Timeout (default 5)