User Manual

Eddy User's Guide
91
S10: Enable Response Message (default 1)
S10=0, Eddy-BT does not send response messages to the host system.
S10=1, Eddy-BT sends response messages to host system.
This value decides whether Eddy-BT sends response messages such as OK, ERROR, CONNECT, DISCONNEC
T or not. When this value is 0, Eddy-BT will not send any response messages. If the response messages confli
cts with your host programs or devices that is connected to Eddy-BT, change this value to 0.
S11: Enable Escape (default 1)
S11=0, Eddy-BT does not allow escape sequence characters. The operation status of Connect cannot be cha
nged to Standby. Since the Eddy-BT skips the process of detecting escape sequence characters, more efficie
nt data transmission can be had.
S11=1, Eddy-BT allows for the escape sequence character. Whenever it is needed, the Connect status can be
changed to Standby.
S12: Clear Data Buffer When Disconnected (default 0)
S12=0, Eddy-BT does not clear the data buffer received from host system when disconnected.
S12=1, Eddy-BT clears the data buffer when disconnected.
S13: Enable DCD Signal (default 1)
S13=0, DCD signal off
S13=1, DCD signal on
S14: Enable DTR Transfer (default 1
S14=0, DTR/DSR signal is transferred in a loop-back fashion..
S14=1, DTR signal is transferred to DSR of remote device.
S15: Enable Disconnect by DTR (default 0)
S15=0, DTR signal cannot release the connection.
S15=1, The Bluetooth connection can be released when DTR signal is off.
This value decides whether Bluetooth connection is released when DTR signal drops or not. If this value is 1, y
ou can use DTR signal in order to disconnect Bluetooth connection.
S22: Faster Connection (default 3)
S22=0, none
S22=1, page scan
S22=2, inquiry scan
S22=3, page/inquiry scan
Connecting time is average 1.5sec faster than normal mode.