User Manual

Eddy User's Guide
71
1. Please power on Eddy-DK after you connect Eddy-BT with Eddy-CPU module.
2. Please set the ‚Operation Mode‛ of 4
th
serial port as ‚Com_Redirector‛ mode. And then, press ‚Sav
e‛ button.
3. Please press ‚Save & Reboot‛ button of ‚Save & Reboot‛ menu. And then, Eddy-DK will be rebooted.
4. Please install COM_Redirector program on PC. (For more information, please refer to the manual of Com_
Redirector program.)
5. Please add port from COM_Redirect Control Panel after the installation of the program.
[* You can see that the 4
th
serial port(192.168.0.223, Port 4004) of Eddy-DK is assigned as COM10.]
6. Please open the port of PC as the default values (9600 bps, None Parity, 8 Data Bits, 1 Stop Bits) using
HyperTermanal.
7. You can connect Eddy-BT with Bluetooth device using AT commands. (For more information, please refer
to ‚Chapter 7.1.4. The meaning of AT commands‛.)
Please press ‚ATZ+‛ and press ‚Enter‛ key. And then, you can see the ‚OK‛ message.
If you see the ‚OK‛ message, Eddy-BT is normally loaded with Eddy-CPU module.
Now you can connect Eddy-BT with Bluetooth device using ‚ATD+Address of the Bluetooth device‛ co
mmand.
If Eddy-BT normally connects with Bluetooth device, you can see the ‚Connect‛ message.