3060386 Geniox OIPM

Geniox Air Handling Unit - User Manual | 3060386
Motor Junction Box Assembly
1. Using supplied hardware, install motor junction box parallel to the EDD assembly onto the I4 front tubing as shown (1).
Caution
Make sure the motor or cable does not stick out of the I4 wheel.
Figure: Correct Junction Box Location
4.5 ERW Seals
The patented AirLoopTM labyrinth seals face the media along the center line of the rotor. (Note that center-line for Geniox units is
horizontal as opposed to the vertical example shown) On the side of the wheel and under the middle pillow blocks, low friction seals
arefactoryinstallandadjusted.Lastly,theS-typelabyrinthperipheralsealsarelocatedontheouteredgeofrotorandxedontheface
plate of the wheel. The overview drawing below shows the seal locations.
Seal Adjustment
The correct adjustment of the AirLoopTM labyrinth seal is obtained by allowing the seal to lightly touch the media before tightening the
screws.
If an initial gap can be seen between the seal and media, the seal is installed too far and should be moved closer until it touches the
media.
ID0002
AIRLOOP™
LABYRINTH SEAL
PERIPHERAL
SEAL
SIDE SEAL
AIRLOOP™
LABYRINTH SEAL
1
4-9 | ERW maintenance