GENIOX SOFTCOOLERV1

Prerequisites for Installation |
5
4.2 Delivery/Unloading
The appliance is delivered in one piece containing all necessary components, wrapped in plastic on a pallet for easy
transportation.
Warning
When opening the transport packaging, there
is a risk of damage from sharp edges, nails,
staples, splinters etc.
Checking delivery
• Check the packaging and the air handling unit for
transport damage. Any findings should be noted on
the cargo manifest.
• Check completeness of the delivery.
Verify that all ordered equipment are delivered before
starting the installation. Any discrepancies from the or-
dered equipment must be reported to the supplier of
Systemair products.
Unpacking
• Unpack the product carefully.
• Check the air handling unit for obvious transport damage.
• Only remove the packaging shortly before assembly.
• Beware of sharp edges during mounting and maintenance. Use protective gloves.
5 Prerequisites for Installation
To ensure a proper and fail-free operation, it is important that the unit is installed according to these instructions.
5.1 Location and Space Requirements
The air handling units are intended for the transport and treatment of air between -40 °C and + 40 °C The units are ex-
clusively for comfort ventilation. The units are not for environments that exceed the corrosion class C4 according to EN
ISO 12944-2 (motors are constructed for handling of air between -20 °C and + 60 °C).
If the unit is installed in a cold place it is important that the unit is not shut-off by the main switch. As long as the main
voltage is on the electrical cabinet will be kept warm also in cold climates.
For service/inspection, a minimum measurement is required in front of the unit, corresponding to the door width of the
box. A space corresponding to the depth of the unit is required when replacing a condenser or an evaporator.
Unit size
Door width Depth of the unit
12 600 1150
14 700 1350
16 700 1550
18 700 1750
20 700 1950
22 800 2150
24 800 2350
Avoid placing the unit against a wall, as low frequency noise can cause vibrations in the wall.
212930 | A001