GENIOX SOFTCOOLERV1

6
| Installation
5.2 Positions and Placement
Geniox Softcooler must always be placed on the warm side of the rotor. In other words, the cooling section has to be
placed between the rotor box and supply air fan box. Geniox Softcooler is produced in four positions: supply air down,
right and left, and supply air up, right and left.
See below for variations:
Supply air down (cooling section marked)
Supply air left Supply air right
5.2.1 Positioning of compressors
The compressor(s) always end up in the extract section. This is a great benefit as you then have good access to the
compressors from the filter side, regardless of the position of the unit.
5.3 Access to Power Supply
Voltage is 3-phase 400 V or 3 phase 230V. An N-conductor must be used with 400 V. Connection is made for Cu wire;
when feeding with AI, an AI/Cu transition is used. Depending on local rules and regulations, correctly dimensioned
earth-fault switches must also be used on power circuits for Geniox Softcooler. Earth-fault switches must be at least
100mA, and one attribute must be adapted to frequency converter operation (EMC-filter must be removed).
6 Installation
Note:
These installation instructions are only a supplement to the Geniox installation instructions; see our website.
Caution
It is important to make sure that the unit is completely level after installation, so that the condensation
water is drained from the tray. It is also important that the cooling section is not tilted more than 30° during
the entire transportation and installation process.
Geniox Softcooler cooling box is either supplied with fitted legs or on a pallet, depending on size.
1. Make sure that the sealing stripes and faces in-between the units halves are undamaged. Place the SoftCooler be-
tween the two air handling units parts and carefully push them completely together.
Note! To avoid any load and stress on the vertical profiles the strap must be carefully placed on the bottom profiles
of the unit when sections are pulled together.
212930 | A001