IOM SYSLOOP (IOM SL 01 S 3GB)

English
42
7.2
23
77.5
65.7
56
56
56
58.1
85.9
120
1.5m 1.5m
20 SYSLOOP
15.1. GENERALITIES
Ensure that the available electrical power supply and the network frequency are matched to the required
operating current, taking account of the appliance’s specic location and the current required to supply any
other appliances connected to the same circuit.
1. Ensure that the unit is supplied with the specied voltage. One stufng box and two grommet holes
are provided on the side of the appliance. They are used respectively for the power and the control
wiring. The power supply line must be properly dimensioned with a motor supply type fuse or a
mains circuit breaker to protect the circuit against voltage surges. (Refer to the Maker’s Plate for the
voltages to be taken into consideration).
2. Always shut down the power supply to the unit before connecting the thermostat wiring.
15.2. REMOTE CONTROL
15.2.1. WALL MOUNTING
1. Separate the remote control from its rear plate.
Checking the support
bracket :
Ensure that the wall surface
is completely at at the
point where you wish to
install the remote control,
as it is important that the
remote control is not twisted
on installation, because any
bending could lead to the
control not clipping together properly and
result in operating difculties.
2. Fitting the rear plate :
² Present the rear plate to the desired location and align it
with a spirit level.
² Mark the screw locations.
² Make a hole or install appropriate plugs according to
the material (wood, concrete, plasterboard etc.).
² Screw the rear plate to the wal.
3. Wire the remote control in accordance with the wiring
diagram.
4. Clip the remote control onto the rear plate.