SYSHRW – Installation Operation Manual (IOM HRW 01 N 21GB)

English
WK
WK
WK
WK WK
1.5m 1.5m
22 SYSHRW
Checking the support bracket :
Ensure that the wall surface is completely at at the
point where you wish to install the remote control, as
it is important that the remote control is not twisted
on installation, because any bending could lead to the
control not clipping together properly and result in
operating difculties.
3. Fitting the rear plate :
² Present the rear plate to the desired location and
align it with a spirit level.
² Mark the screw locations.
² Make a hole or install appropriate plugs according
to the material (wood, concrete, plasterboard etc.).
² Screw the rear plate to the wal.
15. RCX AND µBMS REMOTE CONTROL WIRING
15.1. WALL MOUNTING
4. Insert the rechargeable batteries (supplied with the μBMS).
5. Wire the remote control in accordance with the wiring
diagram.
1. Unscrew the lower screw on the remote control.
2. Separate the remote control from its rear plate.
6. Clip the remote control onto the rear plate.
7. Replace the lower screw in such a way that the remote control
is held rmly in place on the support bracket