IOM SYSCW AR R513A (IOM CWAR 02 N 1GB/12.21)

English
42
7.2
23
77.5
65.7
56
56
56
58.1
85.9
120
1.5m 1.5m
T6
CE
-
CE
+
PB
Lmax = 100 M
21SYSCW-AR R513A
14.2. REMOTE CONTROL
14.2.1. WALL MOUNTING
1. Separate the remote control from its rear plate.
Checking the support
bracket :
Ensure that the wall surface
is completely at at the
point where you wish to
install the remote control,
as it is important that the
remote control is not twisted
on installation, because any
bending could lead to the
control not clipping together properly and
result in operating difculties.
2. Fitting the rear plate :
² Present the rear plate to the desired location and align it
with a spirit level.
² Mark the screw locations.
² Make a hole or install appropriate plugs according to
the material (wood, concrete, plasterboard etc.).
² Screw the rear plate to the wal.
3. Wire the remote control in accordance with the wiring
diagram.
4. Clip the remote control onto the rear plate.
14.2.2. ELECTRICAL CONNECTIONS
The control return must be connected as per the following diagrams.
For the connection, use a KNX TP1 type cable (Twisted pair with insulation) with a 0.8mm² cross-section.
SYSCW-AR - AUTONOMOUS