IOM SYSAER R32 (IOM SYSAER R32 01 N 2GB)
Table Of Contents
- COUVERTURE PREMIERE IOM AER32 01-EN.pdf
- IOM AER32 01-N-GB_text.pdf
- CONTENTS
- 1. GENERAL RECOMMENDATIONS
- 2. INSPECTION AND STORAGE
- 3. WARRANTY
- 4. PRESENTATION
- 5. CONTENTS Of PACKAGE
- 6. DIMENSIONS
- 7. HANDLING
- 8. TECHNICAL SPECIFICATIONS
- 9. CONFIGURATION OF THE UNIT
- 10. OPTIONS
- 11. INSTALLATION
- 12. HYDRAULIC LINKS
- 13. WIRING DIAGRAM AND LEGEND
- 14. ELECTRICAL CONNECTIONS
- 15. COMMISSIONING
- 16. FINAL TASKS
- 17. IN CASE OF WARRANTY - MATERIAL RETURN PROCEDURE
- 18. ORDERING SERVICE AND SPARE PARTS ORDER
- 19. MAINTENANCE
- 20. TROUBLE SHOOTING
- ANNEXE AER32 01-N.pdf
- COUVERTURE DERNIERE IOM AER32 01-EN.pdf
English
The detection system is dependent on the unit’s general power supply. When the unit is not
powered, detection will therefore also stop.
Caution
The unit must only be rendered accessible for maintenance if the client cables connected to
terminals 26 and 27 are disconnected or rendered inoperative upstream of the unit.
Caution
30 SYSAER R32
14.1. GAS DETECTION MODULE
The gas detection module has a dedicated alarm indicator. This information is available via a dry contact
(Normally Closed) by connecting to the unit’s terminals 26 and 27.
Gas sensors must be checked regularly by a competent person. The following must be checked :
² Maintenance/calibration interval not exceeded
² Visual inspection of the sensor, wiring, etc.
² Remove dust deposits, especially at the gas inlet.
14.1.1. INSPECTION
The SYSAER R32 unit is equipped with a gas detection module to ensure the safety of the personnel and
the machine in case of R32 leakage.