IOM SYSAER R32 (IOM SYSAER R32 01 N 2GB)

English
36 SYSAER R32
TASKS PER COMPONENTS ACTIONS
1
month
3
month s
6
months
12
months
24
months
Recommended inspection and maintenance
interval
4 - ELECTRIC CIRCUIT
4.1
Check the electrical voltage applied to the
unit, which must remain stable within the
tolerances specified in the information
plates.

4.2
Check that the main supply cable is void of
alterations likely to impact the insulation.
Replace if required.

4.3
Check the grounding of the metallic
structure
Repair if required.

4.4 Inspect the contacts. Replace if required.

4.5
Check that all electrical connections of the
device are tight
Tighten if required.
 
4.6
Check the thermal protection relays of the
motors
Replace if required.

4.7
Check the nominal intensity and condition
of the fuses.

4.8 Check the condition of the condensers.

4.9
Clean the compressed air electrical unit to
remove any dust or other contaminants
building up.
 
4.10 Check the motor windings are insulated.

5 - FAN(S)
5.1
Check the lack of contamination, corrosion
or damage.
Clean if required

5.2 Check proper fastening of the fan. Tighten if required.

5.3 Check the vanes to guarantee balancing. Clean if required.

5.4 Check the bearings for noise. Repair if required.

5.5 Check the condition of the fan motor.

6 - REGULATION
6.1 Check the condition of the alarms
Acknowledge them after taking
them into consideration

6.2 Check the setting points

6.3 Check the operation of all probes

6.4 Check and clean the smoke detector
Remove any dust that has
accumulated on the fins of the
sensor head, using a vacuum cleaner
or an anti-static cloth.
Clean the sensor assembly with a
sponge or a slightly damp cloth.

6.5 Check the gas detection module
