HandBook F R60K2022 07 11

4/59 | F-R60K
Fire Resistivity
F-R60K fire dampers are CE certified following the Construction Products Regulation according to EN 15650:2010.
Tested according to EN 1366-2:2015 and classified according to EN 13501-3 + A1:2009. The fire damper together
with its installation form an inseparable part of the fire resistivity rating. F-R60K fire dampers are designed for the
installations listed and described in their Handbook.
• Standard supporting construction in accordance with EN 1366-2:2015: EI60 (v
e
- h
o
i↔o)S
• Shaft wall – 2 layer, one side covered plasterboard construction: EI60(v
e
- i↔o)S
Accessories
Detailed information about accessories is available on design.systemair.com
• FCR: Flexible Duct Connection
• R1-F-R60K: Ringlet for Out Installation
Design
Material Composition
F-R60K damper has galvanized sheet metal casing. High temperature resistant insulation ring around the casing from
expanded vermiculite board with inorganic binder. The vermiculite boards are not harmful to health and do not contain
any asbestos, glass or mineral fibers. Blades are made from non-asbestos calcium silicate board with polyurethane
foam seals for cold smoke and an intumescent seal, that expands in case of fire. Ethylene-propylene rubber used as
duct seal. The product contains no hazardous substances, except for the solder in the thermal fuse, which contains one
milligram of lead. All materials are processed in accordance with local regulations.
Activation Types
By default, actuator operated fire dampers are supplied with an actuator with micro switches, optionally with a power
and communication unit. A fire damper can be equipped with a spring return actuator can be closed with command
from the building management system, or after the breaching of the thermoelectric fuse. Actuator operated fire
dampers are standardly equipped with a thermoelectric fuse, that activates the closing of the damper after the
reaching or exceeding of the ambient temperature of 72°C. The actuator power circuit is interrupted, and its spring
closes the damper blade within 20 seconds.
• B230T or G230T
Fire damper with an activation mechanism with a Belimo or Gruner spring return actuator (AC 230 V) with electro-
thermal fuse 72°C and auxiliary switches.
• B24T or G24T
Fire damper with an activation mechanism with a Belimo or Gruner spring return actuator (AC/DC 24 V) with electro-
thermal fuse 72°C and auxiliary switches.
• B24T-W or G24T-W
Fire damper with an activation mechanism with a Belimo or Gruner spring return actuator (AC/DC 24 V) with an
electro-thermal fuse 72°C and auxiliary switches, with provided cable connectors for the supply and communication
unit (communication unit not part of the mechanism).
• B24T-SR or G24T-SR
Fire damper with an activation mechanism with a Belimo or Gruner spring return actuator (AC/DC 24 V) with electro-
thermal fuse 72°C and auxiliary switches for Modulated dampers (possibility to open the blade at the desired angle).
• BST0 or GST0
Fire damper with an activation mechanism with a Belimo or Gruner spring return actuator (AC/DC 24 V) with an
electro-thermal fuse 72°C and auxiliary switches, with a Belimo supply unit BKN230-24 (2-wire) or Gruner supply and
communication unit FSC-UFC24-2 (Modbus/BACnet).
• BST1