Manual

Table Of Contents

4.2.5 Changes Made Function

The changes made function lists all parameters changed from default settings.

• The list shows only parameters that have been changed in the current edit setup.

• Parameters that have been reset to default values are not listed.

• The message Empty indicates that no parameters have been changed.

4.2.6 Changing Parameter Settings

Procedure

1. To enter the Quick Menu, press the [Menu] key until the indicator in the display is placed above Quick Menu.

2. Press [▵] [▿] to select the wizard, closed-loop setup, motor setup, or changes made.

3. Press [OK].

4. Press [▵] [▿] to browse through the parameters in the Quick Menu.

5. Press [OK] to select a parameter.

6. Press [▵] [▿] to change the value of a parameter setting.

7. Press [OK] to accept the change.

8. Press either [Back] twice to enter Status, or press [Menu] once to enter the Main Menu.

4.2.7 Accessing All Parameters via the Main Menu

Procedure

1. Press the [Menu] key until the indicator in the display is placed above Main Menu.

2. Press [▵] [▿] to browse through the parameter groups.

3. Press [OK] to select a parameter group.

4. Press [▵] [▿] to browse through the parameters in the specific group.

5. Press [OK] to select the parameter.

6. Press [▵] [▿] to set/change the parameter value.

7. Press [OK] to accept the change.

Programming

Operating Guide | VLT® HVAC Basic Drive FC 101

AQ275641848264en-000101 / 132R0078