Manual

5 The triangle indicates if the LCP is in Status, Quick Menu, or Main Menu.
B. Menu key
Press [Menu] to select among Status, Quick Menu, or Main Menu.
C. Navigation keys and indicator lights
Table 14: Legend to Section C
6 Com. LED: Flashes during bus communication.
7 Green LED/On: Control section is working correctly.
8 Yellow LED/Warn.: Indicates a warning.
9 Flashing Red LED/Alarm: Indicates an alarm.
10 [Back]: For moving to the previous step or layer in the navigation structure.
11 [▵] [▿] [▹]: For navigating among parameter groups and parameters, and within parameters. They can also be used for setting
local reference.
12 [OK]: For selecting a parameter and for accepting changes to parameter settings.
D. Operation keys and indicator lights
Table 15: Legend to Section D
13 [Hand On]: Starts the motor and enables control of the drive via the LCP.
NOTICE
[2] Coast inverse is the default option for parameter 5-12 Terminal 27 Digital Input . If there is no 24 V supply to
terminal 27, [Hand On] does not start the motor. Connect terminal 12 to terminal 27.
14 [Off/Reset]: Stops the motor (Off). If in alarm mode, the alarm is reset.
15 [Auto On]: The drive is controlled either via control terminals or serial communication.
4.2 Setup Wizard
4.2.1 Setup Wizard Introduction
The built-in wizard menu guides the installer through the setup of the drive in a clear and structured manner for open-loop and closed-
loop applications, and for quick motor settings.
Programming
Operating Guide | VLT® HVAC Basic Drive FC 101
AQ275641848264en-000101 / 132R0078
40 | Danfoss A/S © 2019.11