FC101 Design Guide

Step 3
Place bracket on back of the LCP, then slide down.
Tighten screws and connect cable female side to LCP.
130BB777.10
Figure 4.4 Place Bracket on LCP
Step 4
Connect cable to frequency converter.
130BB778.10
Figure 4.5 Connect Cable
NOTICE!
Use the provided thread-cutting screws to fasten the
connector to the frequency converter. The tightening
torque is 1.3 Nm (11.5 in-lb).
4.2.3 IP21/NEMA Type 1 Enclosure Kit
IP21/NEMA Type 1 is an optional enclosure element
available for IP20 units.
If the enclosure kit is used, an IP20 unit is upgraded to
comply with enclosure IP21/NEMA Type 1.
130BB902.12
A
B
C
OK
Alarm
Warn.
On
B
a
c
k
Hand
On
Reset
Auto
On
Status
Quick
Menu
Main
Menu
Figure 4.6 H1–H5 (See Data in Table 4.4)
Selection and Ordering
VLT
®
HVAC Basic Drive FC 101
50 Danfoss A/S © 04/2018 All rights reserved. MG18C822
44