Manual VLP

VLP
19
EN
Actuator (SDM24)
Dimensions and technical specifications
Application
The actuator (SDM24) is modulated and gives
the correct heat. SIRe can be set to always
allow a small leakage flow through. This is
to provide quick heat supply when a door is
opened but also to provide a degree of frost
protection.
Function Modulating 0-10 V
Supply voltage 24 AC ±15%, 50-60 Hz
Power consumption 2,5 VA at max. power supply
1,5 W - active
Nominal force 120 N +30% / -20%
Maximum stroke 6 mm (3,2 / 4,3 /6)
Running time 8 s/mm
Protection class IP43
Fitting thread M30x1,5
Cable L = 1,5 m, (3 x 0,35 mm²)
Ambient operating
condition
0 - 50°C, non condensing
Ambient storage
condition
-20 - 65°C, non condensing
Max. water
temperature
95 °C
Sound level <30 dB(A)
Weight 0,2 kg
Colour White semi transparent
Material housing
PA66 - Glass + Mineral filled
(30% total)
Kelon A FR CETG/300-VO
Material fitting Brass CuZn40Pb2
CE-Compliance
Directive 89/336 EEC;
EN 61000-6-1; EN 61000-6-3
Operating status indication
Function
Actuator is controlled by a 0-10 V signal.
The valve is open in unaffected position.
The actuator should be in "Reverse Action,"
dipswitch no. 4 should be set to ON, which
means that at 10 V, the valve is unaffected,
ie fully open for heat input. In the closed
position SIRe still gives an output of 0.5 V to
pass through a small leak flow through the
valve.
The actuator is self-calibrating and sets the
end positions by itself.
Dipswitch settings
SDM24 is adjustable, this is done by setting
dipswitches. These are located under the
actuator cover. To SDM24 to work with SIRe,
dip no. 4 should be set to = ON as follows, i.e.
"Reverse Action":
OFF No power supply
Green Flashing Moving to position
Green Flashing End stroke confir-
mation
Green steady
On
Position reached
Red Flashing Cycle
Red steady On 4/20mA or 2/10Vdc
signal lost
80 mm
79,5 mm
49 mm
ON
1
2 3 4 5 6