Installation , Operation and Maintenance Instructions Genius

Parameters Change parameters in the service level:
" Move with the RIGHT, LEFT, UP and DOWN buttons to scroll through the menus
until you reach the parameter you want to change.
" Push OK button.
» The cursor is positioned at the adjustable parameter.
" Increase or decrease the values with the up or down buttons.
" Push OK button.
» The new value is now conrmed.
Change parameters in the service level:
" Move with the RIGHT, LEFT, UP and DOWN buttons to scroll through the menus
until you reach the parameter you want to change.
" Push OK button.
» The display shows the Log on menu:
" Enter the service password.
" Push OK button.
» The cursor is positioned at the adjustable parameter.
" Increase or decrease the values with the up or down buttons.
" Push OK button.
» The new value is now conrmed.
11.3 Alarm Log
NOTE
The alarm log of the unit can only be read by the display. Therefore, it is especially important in case of service to have
access to it. Access to the alarm log is described on „Alarm event“ page 91."
11.4 Read Alarm
If the Alarm LED is ashing, one or more active alarms can be read by pressing the red alarm button.
Alarms can be directly conrmed, blocked or released.
Block and release is only available after entering the service password "1111". The log on window appears automatically, if necessary.
Example
Error extract air fan
20 Nov 12:54 Class: B
Cancelled
Conrm with
OK
Error extract air fan
Conrm
Block
Conrm
Conrm with Conrm
The alarm is conrmed
Block
Conrm with Conrm
Log on
Log on
Enter password: 1111
Actual level: none
88
Control via Display
Genius - V 1.0