Installation , Operation and Maintenance Instructions Genius

Genius
Extract air fan I-time 20 s
Speed at intense ventilation 70 % Room designation Bedroom
Speed at nominal ventilation 60 % Room 3
Speed at reduced ventilation 35 % Room sensor internal
Speed at hum. protect. ventilation... 15 % Setpoint room temperature 20.0 °C
Speed at night cooling 85 % Temperature rise + 3 °C
Secondary air fan Temperature setback - 3 °C
Parallel offset speed 100 % P-band 3 °C
Min. speed 60 % I-time 20 s
max. speed 90 % Room designation Lea
Power limitation Room 4
Activate No Room sensor internal
WP max. 100 % Setpoint room temperature 20.0 °C
Rotor Temperature rise + 3 °C
Cooling recovery default value 2 °C Temperature setback - 3 °C
Stop rotor default value 2 °C P-band 3 °C
Defrost. level 3 I-time 20 s
add. frost protection On Room designation Jan
Hot Water Room 5
Start charge pump if HW temp. < S... 1 °C Room sensor internal
Stop charge pump if HW temp. > S... 2 °C Setpoint room temperature 20.0 °C
Extended running pump 150 s Temperature rise + 3 °C
Default value time program Automatic Temperature setback - 3 °C
PTC P-band 3 °C
PTC function Off
≡
I-time 20 s
≡
PTC start delay 45 min Room designation Ofce
PTC defrost power HP 20 % Room 6
Switch-off point -20 °C Room sensor internal
Setpoint preheater -10 °C Setpoint room temperature 20.0 °C
P-Gain preheater 2 Temperature rise + 3 °C
Night cooling Temperature setback - 3 °C
Night cooling activated No
P-band 3 °C
Activated at outdoor temperature 22 °C I-time 20 s
Max. outdoor temp. night 18 °C Room designation Entrance/Cor-
ridor
Min. outdoor temp. night 5 °C
min. room temperature 20 °C
Filter alarm
Reset lter life No
Number of months for lter change 12
Number of months since last lter change 1
e-mail
Alarms via e-mail No
e-mail address
Sender name Systemair
Re: Alarm Genius
63
Genius - V 1.0
Operation/Control via Internet/App