Installation , Operation and Maintenance Instructions Genius

7.3.3.4 Setting the Maximum Power
This function is only needed if, due to a very low heating/cooling load, the unit/duct network was not congured according to the maxi-
mum possible power/air quantity.
In this case, the maximum speed of the secondary air fan and, automatically with it the maximum heating/cooling power (not the power
for hot water production) must be limited: according to the specications of the planer/the conguration by Systemair.
Secondary air fan
Parallel offset speed 100 %
Min. speed 60 %
Max. speed setback operation 90 %
Power limitation
Activate No
WP max. 100 %
NOTE
These parameters should normally not be changed.
" Use this function only after consulting a specialist company or specialised personnel!
30
Commissioning
Genius - V 1.0