Installation , Operation and Maintenance Instructions Genius
7.3 Internet Connection
The controller is precongured for Internet access. It is connected to the TCP/IP interface with the router via a network cable. Subse-
quently, the router will automatically issue an IP address to the controller. This must be read out from the router settings.
7.3.1 Log on
" Start internet browser
" Enter the IP address to the command line.
The log on screen will be displayed.
" Save the log on page to the favourites and rename it if required.
7.3.2 Passwords
Delivery setting
User level: guest
Service level: operator
7.3.3 Settings
7.3.3.1 DeneRoomAddresses
Establish a connection from the controller to the building service centre to activate the room controller. First visit the website to dene
the room addresses in "Settings, activate supply air rooms".
" Log on to the website.
" Dene the room addresses with Settings room addresses.
Types and addresses can be found at the rear side of the room controller (inside). The following example shows the address composition.
(see „10.8.1.6 Activate Supply Air Rooms/Room Controller“ page 77)
Example RC-CDO149.039
RC-CDO Sensor type
149
039 ModBus address (relevant address for the network connection)
Settings
Activate supply air rooms
Number of rooms 6
Room 1
Modbus room address (ELA) 197
Room 2
Modbus room address (ELA) 39
Room 3
Modbus room address (ELA) 147
Room 4
Modbus room address (ELA) 82
Room 5
Modbus room address (ELA) 237
Room 6
Modbus room address (ELA) 200
27
Genius - V 1.0
Commissioning