VTK INSTALLATION INSTRUCTION

2
|
Accessories
4 Accessories
Filter and accessories are available at www.systemair.com.
4.1 Mounting washers
1. Turn the airvent’s plate counter clockwise from auto mode and detach.
2. Mount the washers to desired gap opening on the guide, add 2 mm (the stud on
the washer shall run in the track of the guide).
3. The washers are available in 2 and 4 mm thickness. A 4 mm washer provides 2
mm gap opening. One 4 mm + 2 mm washer provides a 4 mm gap opening.
4. Turn the plate to auto mode.
4.2 Filter change
It is recommended to change the filters between 1-3 years interval depending on placement and air quality.
1. Mount the filter first on the airvent. Ensure that the
filter encloses the venting house and the rubber seal.
2. Push the airvent and filter in to the duct.
3. If correctly mounted, the gasket should hold the
airvent firmly in the duct, no screws are necessary.
| A001