PULSER M DATASHEET

Installation
The electric heating controller is connected in series
between power supply and an electric heater, for example
an electric heating battery or electric panel. It is mounted
on a wall. If the unit is to be used with the internal sensor,
it should be mounted approximately 1.5 m above floor
level at a location with a representative temperature and
good air circulation.
When the electric heater is larger than the capacity of the
controller the load can be split and controlled in
combination with the ancillary unit PULSER-ADD.
HEAD OFFICE SWEDEN
Phone: [phone]
Web: www.regincontrols.com
E-mail: [e-mail]
PULSER-M
— 2 —