WD VTC 200 MUL 20210315 075213095

Wiring Diagram SAVE VTC 200
4 (7)
Symbol Description
SAF
Supply air fan.
EAF
Extract air fan.
SAT
Supply air temperature sensor.
1
ECT
Extra controller temperature sensor
MR
Overheat protection with manual reset.
AR
Overheat protection with automatic reset.
RL
Relay, switch signal 24V DC
EMI
Electromagnetic interference filter for 230 V AC.
HMI
Integrated control panel
ELH
Electrical heater battery.
CB
Connection to external connection board.
OHT
Overheat protection sensor.
2
OAT
Outdoor air sensor.
FPT
Frost protection sensor
3
M-EMT
Emergency thermostat, manual reset 120°C (normally closed contact)
A-EMT
Emergency thermostat, automatic reset 60°C (normally closed contact)
RHS/EAT Internal relative humidity/Extract air temperature sensor.
E
External control panel.
C
Motor control (bypass damper).
D
Damper motor 230V~ (bypass damper).
WH
Water valve actuator, heating.
4
WC
Water valve actuator, cooling.
5
U
Damper motor Outside air.
V
Damper motor Exhaust air.
BU
Blue.
BN Brown.
BK
Black.
RD
Red.
YE
Yellow.
GY
Gray.
WH
White.
GN Green.
1
For water heating/cooling battery,
2
Units with electrical re-heater battery.
3
For water heating battery.
4
Water heater can be connected to any free analog output (AO) either on connection board or main board
and then configured in HMI.
5
Water cooler can be connected to any free analog output (AO) either on connection board or main board
and then configured in HMI.
Systemair UAB Linų st. 101, LT–20174 Ukmergė, LITHUANIA
Phone: [phone] Fax: [phone] 254526-en_GB- v01