SAVE VTC 200 SERVICE AND ACCESSORIES INSTALLATIONV1 1
Table Of Contents
- 1 Overview
- 2 Important Safety Information
- 3 Configuration
- 4 Service
- 5 Troubleshooting
- 6 Accessories
Service
|
25
4.3.1.3 Heat exchanger
SAVE VTC 200 is equipped with a counter flow heat exchanger. Required supply air temperature is therefore normally
maintained without adding additional heat.
4.3.1.4 Main circuit board
The main circuit board controls all functions and the unit.
It is possible to connect external accessories to a free terminals on the main circuit board.
4.3.1.5 Connection box
Connection box is placed outside of the unit. It contains connection board. All external accessories can be connected to
the unit via connection board with freely configurable terminals.
4.3.1.6 Temperature sensors
The sensors are connected to the main circuit card. See wiring diagram for more information.
4.3.1.7 Humidity sensor
Relative humidity sensor (RHS/EAT) is positioned in the extract air chamber and connected to the main circuit board.
See wiring diagram for more information.
4.4 Electrical connection
The SAVE VTC 200 is wired internally from factory.
The electrical connection box is on top of the unit behind a cover plate.
4.4.1 Main circuit board layout
The SAVE VTC 200 is equipped with built-in regulation and internal wiring.
| v1.1