SAVE VTR 700 INSTALLATIONV1 20210507 101120855

Electrical connections |
9
It is very important to insulate cold ducts and joints tightly without any gaps, otherwise there is a risk of condensation
which may result in moisture damage.
Do not install the ducts directly against structural building elements to avoid sound propagation. Use acoustic insulation
and sound attenuators.
Note:
The type of ventilation ducts and insulation differ for each building and climate zone. If the ventilation
drawing is not provided, please contact your installer or place of purchase for recommendations.
6.3 Installation and Configuration of Accessories
Please follow instructions included with the accessory or consult “Service and Accessories Installation” manual which
can be found in our online catalogue.
7 Electrical connections
The SAVE VTR 700 is wired internally at factory.
The electrical connection box can be found behind a cover plate (pos. 1). The main circuit board (pos. 2) can easily be
taken out from the unit.
Fig. 6 Main circuit board position
7.1 Main circuit board layout
The SAVE VTR 700 is equipped with built-in regulation and internal wiring.
254524 | v01