SAVE VTR 100B INSTALLATIONV1

16
| Installation
measurement 102; see figure 14, pos. A. The cooker hood brackets are adjustable to fit various cupboard depths (fig-
ure 14, pos. B).
2. Move the cooker hood brackets without fully tightening the screws and adjust the brackets so that they fit the sides
of the cupboards (figure 14, pos. C). Hang the cooker hood in the pre-installed screws in the side of the cupboard.
Tighten the screws in the bracket and on the wall (figure 14, pos. D). Lock the brackets into position using the locking
screws (figure 14, pos. E).
Mounting the unit with the cooker hood installed using brackets
1. Pull the cooker hood power supply and control cables to the top since the mounted SAVE VTR 100/B unit will block
access to the back.
2. Once all cooker hood cables at the back are led to the top, lift the unit and hang it on the mounting bracket.
3. Connect the cooker hood and the SAVE VTR 100/B unit using flexible duct.
7.4.3 Optional installation in a cupboard with a base
1.
Fig. 15 Dimensions of a hole in the base of the cupboard
Using a saw, cut out a hole in the base of the cupboard. When the SAVE VTR 100/B unit is mounted directly on the
wall, the minimum distance from the wall to the hole has to be 55 mm (figure 15, pos. A).
Note:
Be sure to add the thickness (dimension X) of your wooden blocks if they were used (figure 15, pos. B).
Fig. 16 Installation using brackets
2. Attach the brackets as far into the cooker hood as pos-
sible. Insert the cooker hood up into the hole in the
base of the cupboard. Pull out (figure 16, pos. A) and
use screws to fasten the brackets to the sides of the
cupboard (figure 16, pos. B). Tighten the brackets in
the cooker hood.
254537 | v2