SAVE VTR 100B INSTALLATIONV1
Table Of Contents
- 1 Overview
- 2 Important Safety Information
- 3 Technical Data
- 4 Delivery, Transport, Storage
- 5 Prerequisites for Installation
- 6 Connection box installation and switching orientation from Right-hand to Left–hand
- 7 Installation
- 8 Electrical connections
- 9 Before Starting the System
- 10 Commissioning
- 11 Concluding Routines
- 12 Disposal and recycling
- 13 EU Declaration of Conformity
Installation |
15
Fig. 13 Placing the unit on the mounting bracket
2. Once all cooker hood cables at the back are led to the top, lift the unit and hang it on the mounting bracket.
Warning
Beware of sharp edges during mounting and maintenance. Use protective gloves.
Consider the unit weight when mounting!
Note:
Make sure that the unit is completely vertical and horizontal once mounted on the wall. Check with a spirit
level.
Make sure there is at least 2 mm gap between the unit and the cupboard to prevent vibration noises.
7.4.2 Installation between or in a cupboard without a base using brackets
When the cooker hood cannot be attached directly to the unit, use included brackets. Flexible duct is needed to connect
the cooker hood with the SAVE VTR 100/B unit when using this type of installation.
1.
Fig. 14 Installation using brackets
Mark out and fasten screws so that they protrude a few millimetres from both cupboard sides (figure 14, pos. A). If it
is intended to align the underside of the cooker hood with the underside of the row of cupboards, use the upper
254537 | v2