SAVE VTR 100B INSTALLATIONV1

Installation |
11
If the wall is from a thick concrete or bricks, no special preparation is needed (figure 6, pos. A), otherwise make nec-
essary adjustments (figure 6, pos. B). The unit weights 39 kg.
Make sure there is a power socket is located nearby the unit, preferably above it. It must be earthed. SAVE VTR 100/
B power cable length is 1 – 1,5 m and it comes out from the top left side in right version units and from the right top
side in left version units. Choose power socket location accordingly.
Fig. 7 Installation of mounting bracket without or with wooden blocks
2. Screw the mounting bracket (pos. 1) with the anti-vibration pad (pos. 2) to the wall (figure 7, pos. A). Screws are not
included, choose them based on your wall type. Use appropriate holes to screw the bracket firmly to the wall. Bottom
side of bracket should be 40 mm (H) below top of unit position.
Leave 15 mm gap between the mounting bracket and the cupboard for the cooker hood wires.
Note:
Make sure that the mounting bracket is completely horizontal once mounted on the wall. Check with a spirit
level.
In case the depth of cabinets is much greater than the unit, install wooden blocks (pos. W) to compensate the missing
distance (figure 7, pos. B). Then install the mounting bracket on the upper block. Choose thickness of blocks according
to your needs.
Thickness of wooden blocks should be 25–100 mm. If needed distance is lower than 25 mm, adjust bolts instead of us-
ing wooden blocks (see figure 19).
Caution
Be sure to select the appropriate type and length of the screws so that they could hold additional wood
blocks and the unit itself.
254537 | v2