450222 FC OIPM

ø 8.5 (2x)
Installation Manual
FC Series
Fast Clamps
Warning
Sheet metal will have sharp edges. Always
protect your hands during installation.
The tabs are sized for the weight of the fan.
The duct should be supported by other
means. Always consult local code when
installing our products. If special supports
are required in anticipation of earth quakes,
the FC clamps are not intended to meet
these requirements.
General Information
The FC Clamps are intended to simplify fan
installation and isolate fan vibration from
rigid metal duct. FC Clamps are convenient
in installations where regular removal of the
fan is necessary for inspection and cleaning.
FC Clamps are available in sizes 4” through
20” to fit corresponding duct sizes.
FC Clamps in sizes 4” through 12” are
equipped with integral hanging tabs. When
used with model FR or FG fans, these tabs
can be used to suspend the fans. If used for
that purpose, two FC clamps are required.
DO NOT hang FKD Series fans from these
tabs. FKD fans are equipped with integral
brackets for suspended installation.
Installation instructions
1. To minimize vibration, leave a gap of
1
/
4
”
between fan collar and duct.
2. Tighten the two screws until the fan and
duct are snugly attached.
3. If using FC Clamps to support a fan (FR
and FG only), drive two pc. sheet metal
screws through the FC Clamp and into
the collar of the fan.
DO NOT over tighten, the screws are to
ensure that the clamp does not slip off
the fan.
4. If the fan is to be suspended from the
integral hanging tabs (FG and FR fans only);
Follow steps 1 & 2 in the illustration:
Hanging tabs ø 8.5 (2x)
(FC 4 to 12)
Hanging tabs
(FC 4 to 12)
ø 8.5 (2x)
1. Fold out the tabs as
shown using needle-
nose pliers.
2. Hang the fan using
suitable hardware.
Item #: 450222
Rev Date: 2016-05-18
United States
10048 Industrial Blvd., Lenexa, KS, 66215
Tel.: [phone] • Fax: [phone]
Canada
50 Kanalflakt Way, Bouctouche, NB, E4S 3M5
Tel.: [phone] • Fax: [phone]