SRC technical documentation (IOM SRC 01 1GB)

1/2
Occ.
Occupancy
18.5°C
Setpoint
Auto
Speed
OFF
Status
Auto
Mode
WSHP Address 1
1/2
0.0°C
Return air temperature
0.0°C
Indoor coil temperature
0.0°C
Leaving water temperature
0.0°C
Air probe
WSHP Address 1
ON
OFF
A
AUTO
05.02.2020
13:35
Zone 1
Home
18.5°C
Setpoint
High
OFFCooling
Speed
StatusMode
No active alarms

i
System preferences
Unit information
Settings
Alarms
Scheduling
Air handling unit
Chiller
Fan coil
Menu
ON
OFF
A
AUTO
05.02.2020
13:35
Zone 1
Home
18.5°C
Setpoint
High
OFFCooling
Speed
StatusMode
2 active alarms

i
System preferences
Unit information
Settings
Alarms
Scheduling
Air handling unit
Chiller
Fan coil
Menu
Information
For type A fan convector unit zones, the communication alarms of the different units will only appear
when a value change is sent to them.
Information
If the heat pump on water circuit is not congured to use the temperature sensor on a remote
control, the value displayed in the “Air return sensor” eld is equivalent to that in the “Air return
temperature” eld.
28 SRC
The SRC is used to act individually on the following:
² operating mode
² unit status
² ventilation speed
² ambient setpoint(s)
² in use/not in use
It is also possible to check the temperature measured by
the:
² air return sensor (remote control sensor)
² water ow sensor
² evaporator unit sensor
² air return sensor
8. ALARM
The SRC can report alarms on units. The information is displayed:
² on the home page
the eld species the number of alarms
² on the menu
the “Alarms” menu is displayed in black if at least
one alarm is active