SRC technical documentation (IOM SRC 01 1GB)


i
System preferences
Unit information
Settings
Alarms
Scheduling
Air handling unit
Chiller
Fan coil
Menu
Factory reset
Change password
Zone devices
Zone name
Configure addresses
DIP Config.
Fan coil A
Fancoil type
µBMS
SRC type
Settings
Factory reset
Settings
Zone of water source heat pump
Single water source heat pump
Cancel OK
Zone of fan coils (A)
Single fan coil (A)
µBMS
SRC type
1
SRC type
2
0
987
654
321
Factory reset
Settings
Enter Service password
Cancel
OK
9201
Fan coil A
Fancoil type
µBMS
SRC type
2
1
Resets all settings to default
Factory reset
Change password
Zone devices
1
DIP Config.
Zone of fan coils (A)
SRC type
Settings
1
1 ... 7
1
Resets all settings to default
Factory reset
1
SRC type
Settings
OKCancel
DIP Config.
2
1
Resets all settings to default
Factory reset
Change password
Zone devices
1
DIP Config.
Zone of fan coils (A)
SRC type
Settings
2
+
Zone devices
Address 1
Device 1
1
+
1 ... 247
36
Zone devices
Device 1
1
OKCancel
Device address
2
1
+
Zone devices
ReleaseAddress 36
Device 2
Address 1
Device 1
1
15SRC
5.3. FAN CONVECTOR UNIT ZONE
The conguration must be carried out according to the following process:
1. denition of the fan convector unit type conguration
2. address conguration
In this operating mode, the SRC can control a maximum of 31 type A fan conductor units.
The DIP Cong. corresponds to the technical specications of the fan convector unit type (Refer to the § FAN
CONVECTOR UNIT B, page 12).
The declared address must be the same as that of the fan convector unit. The address can be between 1
and 247. All addresses must be unique.