SRC technical documentation (IOM SRC 01 1GB)

Factory reset
Change password
Zone devices
Zone name
Configure addresses
DIP Config.
Fan coil A
Fancoil type
µBMS
SRC type
Settings
1
1/3
Zone 5
Zone 4
Zone 3
Zone 2
Zone 1
Zone name
1
1/3
.123
onbvcxz
lkjhgfdsa
poiuytrewq
Zone 5
Zone 1
Zone name
Zone name
Cancel
OK
1/3
Zone 5
Zone 4
Zone 3
Zone 2
Chiller
Zone 1
Zone name

i
System preferences
Unit information
Settings
Alarms
Scheduling
Air handling unit
Chiller
Fan coil
Menu
Factory reset
Change password
Zone devices
Zone name
Configure addresses
DIP Config.
Fan coil A
Fancoil type
µBMS
SRC type
Settings
Factory reset
Settings
Zone of water source heat pump
Single water source heat pump
Cancel OK
Zone of fan coils (A)
Single fan coil (A)
µBMS
SRC type
1
SRC type
2
0
987
654
321
Factory reset
Settings
Enter Service password
Cancel
OK
9201
Fan coil A
Fancoil type
µBMS
SRC type
2
1
Resets all settings to default
Factory reset
Change password
1
Device addresses
1
DIP Config.
Single fan coil (A)
SRC type
Settings
1
Resets all settings to default
Factory reset
Change password
1
Device addresses
1
DIP Config.
Single fan coil (A)
SRC type
Settings
2
1 ... 7
1
Resets all settings to default
Factory reset
1
SRC type
Settings
OKCancel
DIP Config.
2
1
1 ... 247
1
Resets all settings to default
Factory reset
1
SRC type
Settings
OKCancel
Device address
1
14 SRC
5.1.5. NAME ZONES
Select a zone from the proposed list (zone 1, zone 2, etc.) to name it.
5.2. FAN CONVECTOR UNIT ONLY
In this operating mode the SRC can only control one type A fan conductor unit.
The DIP Cong. corresponds to the technical specications of the fan convector unit (Refer to the §
FAN CONVECTOR UNIT A, page 12). It is imperative that all fan convector units have strictly the same
conguration.
The declared address must be the same as that of the fan convector unit. The address can be between 1
and 247.
The conguration must be carried out according to the following process:
1. denition of the fan convector unit conguration
2. address conguration