UM AER 01 N 1GB
Table Of Contents
- CONTENTS
- 1. INTRODUCTION
- 2. INPUTS/OUTPUTS DESCRIPTION
- 3. ROOM AIR TEMPERATURE CONTROL
- 3.1. SUMMER/WINTER SWITCHING
- 3.2. UNIT ON/OFF
- 3.3. COMPRESSOR CONTROL
- 3.4. DEFROST MODE
- 3.5. MAIN FAN
- 3.6. TEMPERATURE-BASED FREECOOLING AND FREEHEATING CONTROL
- 3.7. THREE DAMPERS ECONOMIZER OPTION
- 3.8. Supply air temperature minimum limit
- 3.9. FRECO OPTION
- 3.10. THERMODYNAMIC RECOVERY OPTION - TRECO
- 3.11. AUXILIARY HEATING
- 3.12. Set point compensation
- 4. ROOM AIR QUALITY CONTROL
- 5. SMOKE DETECTOR
- 6. SCHEDULING
- 7. USER INTERFACE
- 8. ALARM MANAGEMENT
- 9. SERVICING (CAREL)
- 10. MENU DESCRIPTION (CAREL)
English
Trm3 None — Ok?No
Trm2 31 Sh
Trm1 32 Sh
P:11 Adr Priv/Shared
Trm3 None — Ok?No
Trm2 None —
Trm1 32 Sh
P:11 Adr Priv/Shared
Unit n: 11
unit:
change controlled
Press ENTER for L0
31SysAer
7.7. ACCESS TO THE UNITS OF THE PLAN NETWORK VIA THE SINGLE TERMINAL
REMOTE TERMINAL
+
LOCAL TERMINAL
With all the controllers and one or a few displays congured for PLAN network, it is possible to display the
parameters of each unit with one display.
In the main menu (Prg key), select the UNIT SELECTION item. The following screen will be displayed:
By pressing ENTER, the display will jump to the next available address of controller in the PLAN network. It
is not possible to directly select the unit to be displayed.
² In the display address of Trm1, put the address
of the display (32 for the example). Press
ENTER. In the Pr eld of Trm1, put Sh (with the
UP and DOWN keys):
² Press ENTER ve times. In the No eld, put Yes and press ENTER. The rst screen of the Rooftop
software should be displayed now.