SYSTEMP – Installation Operation Manual (IOM SYSTEMP rev.N)

22
2.3 UNIT POSITIONING
2.3.1 UNIT POSITIONING WITH WINCH HOIST
To remove the unit from the wood pallet for nal positioning, use one or more winch lifters of sucient capacity (see previ-
ous chapters). Proceed as follows for the handling operations:
1) Remove the straps and clamps on the wooden pallet.
2) Push the winch lifters to the edge of the pallet while holding it securely.
3) Make sure the lifting parts of the winch lifters are positioned at the bottom of the unit.
4) Secure the units to the winch hoists by means of safety ropes, to avoid accidentally dropping the unit.
5) Lift the unit and remove the wooden pallet.
6) Bring the unit to the nal installation position, taking care not to tilt it, thereby risking damage or drops.
7) Should the units need to be placed on a base or plenum, ensure this is already in the nal installation position (see following
chapters).
8) When placement is completed, remove the safety beds and extract the winch hoists.
Handling with winch hoist
2.3.2 WHEELS TO SET SERIES R IN POSITION (ACCESSORY)
R series units can be equipped with 4 wheels at the corners of the unit to facilitate handling during installation. If these
wheels are ordered, they are supplied pre-installed, therefore, they will only need to be removed from the wooden pallet.
Positioning wheels