SYSTEMP Engineering Data Manual (EDM SYSTEMP S 7GB)

42
Plenum and base frame (accessory)
Various types of air distribution plenum and base frame are available as accessories for both the Under (U) and Over
(O) versions of the unit.
When installing plenums and base frame, it is advisable to place a gasket (rubber or similar material) of an adequate
thickness and length, between them and the machine to avoid transmitting vibrations to the structure. Placing this gasket in
between also ensures the air seal between the two elements and contains the noise level of the installation.
Below are the various types of available plenums and base frame:
Type Front view Right – Left Side View
Plenum with opaque panels (Drill-
ing must be carried out by the
customer)
G series ventilated plenums with
solid panels
Plenum with front grille
G series ventilated plenums with
front grilles
Plenum with front and side grilles
Soundproofed duct section
Free-cooling plenum
Adjustable plinths
Ventilated plinths (G series)
|
Dimensions and clearances