IMO AW 450 EC SILEO DE,EN

Operating instructions
3.2 Nominal data
Motor M3G084-FA
Phase 1~
Nominal voltage / VAC 230
Nominal voltage
range / VAC
200 .. 277
Frequency / Hz 50/60
Method of obtaining
data
ml
Speed (rpm) / min
-1
1300
Power consumption /W 345
Current draw / A 2.2
Max. back
pressur
e /
Pa
125
Min. ambient
temperature / °C
-25
Max. ambient
temperature / °C
60
ml = Max. load · me = Max. efficiency · fa = Free air
cs = Customer specification · ce = Customer equipment
Subject to change
3.3 Data according to ErP Directive
Actual Req. 2015
01 Overall
efficienc
y
η
es
/
%
42.6 30.7
02 Measurement category A
03 Efficiency category Static
04 Efficiency grade N 51.9 40
05 Variable speed drive Yes
06 Year of manufacture
The year of manufacture is specified on the
product's rating label.
09 Powe
r
consumptio
n
P
ed
/
kW
0.34
09 Air flow
q
v
/
m³/h
4005
09 Pressure
increase
total
p
sf
/
Pa
118
10 Speed (rpm)n/ min
-1
1305
11 Specific ratio
*
1.00
12 Recycling/disposal
Information on recycling and disposal is
provided in the operating instructions.
13 Maintenance
Information on installation, operation and
maintenance is provided in the operating
instructions.
14 Additional components
Components used to calculate the energy
efficiency that are not apparent from the
measurement category are detailed in the
CE declaration.
*
Specific ratio = 1 + pfs / 100 000 Pa
Data obtained at optimum efficiency level. The ErP data is determined using a motor-impeller
combination in a standardized measurement setup.
3.4 Technical description
Weight 10.4 kg
Fan size 450 mm
Rotor surface Painted black
Terminal box material PC/ABS plastic
Electronics housing
material
Die-cast aluminum
Blade material Press-fitted sheet steel blank, sprayed
with PP plastic
Fan housing material Sheet steel, pre-galvanized and coated
with black plastic (RAL 9005)
Guard grille material Steel, coated with black plastic (RAL
9005)
Number of blades 5
Airflow direction "A"
Direction of rotation Clockwise, viewed toward rotor
Degree of protection IP54
Insulation class "B"
Moisture (F) /
Environmental (H)
protection class
F3-1
Installation position Shaft horizontal or rotor on bottom; rotor
on top on request
Condensation
drainage holes
On rotor side
Mode S1
Motor bearing Ball bearing
Technical features - Output 10 VDC, max. 1.1 mA
- Alarm relay
- Motor current limitation
- Soft start
- Control input 0-10 VDC / PWM
- Control interface with SELV potential
safely disconnected from the mains
- Thermal overload protection for
electronics/motor
- Line undervoltage detection
Touch current
according to IEC
60990 (measuring
circuit Fig. 4, TN
system)
<= 3.5 mA
Electrical hookup Via terminal box
Motor protection Thermal overload protector (TOP)
internally connected
Protection class I (with customer connection of protective
earth)
Conformity with
standards
EN 61800-5-1; CE
Approval CSA C22.2 No. 77; EAC; UL 2111
With regard to cyclic speed loads, note that the rotating parts of
the device are designed for a maximum of one million load
cycles. If you have special questions, consult Systemair for
support.