SYSHP MINI EVO P – Installation Operation Manual (IOM SYSHP MINI EVO P S 1GB)

51
15.1 M1M2 0 /
15.2 SMART GRID 0 /
15.3 T1T2 0 /
15.4 Tbt
0
/
16.1
16.2 TIME_ADJUST
16.3
17.1
17.2
PER_START Start-up percentage of multiple units 10
%
Adjustment time of loading and unloading units 5
min
ADDRESS RESET Reset the address code of the unit FF
/
HMI SET 0
/
HMI ADDRESS FOR BMS Set the HMI address code for BMS 1
/
Order
number
Code State Default
Unit
Define the function of the M1M2 switch：0= REMOTE
ON/OFF,1= TBH ON/OFF,2= AHS ON/OFF
Enable or disable the SMART GRID：0=NON,1=YES
Control options of Port T1T2：0=NON,1=RT/Ta_PCB
Enable or disable the Tbt：0=NON,1=YES
18.1
18.2
18.3
18.4
18.5
18.6
18.7
18.8
t_DELAY PUMP
The time that the compressor has run before starting the pump.
t1_ANTILOCK PUMP
The pump anti-lock interval time
t2_ANTILOCK PUMP RUN The pump anti-lock running time.
t1_ANTILOCK SV The valve anti-lock interval time.
t2_ANTILOCK SV RUN The valve anti-lock running time.
Ta_adj. The corrected value of Ta inside wired controller.
F-PIPE LENGTH
Select the total length of the liquid pipe(F-PIPE
LENGTH)：0=F-PIPE LENGTH<10m,1=F-PIPE
LENGTH>=10m
PUMP_I SILENT OUTPUT The pump_I max output limitation.
2
24
60
24
30
-2
0
100
min
h
s
h
s
/
%
°C
The setting range of the above parameters can be queried by scanning the QR code below.The QR code also includes:
1) FOR SERVICEMAN (The password to enter FOR SERVICEMAN is 234)
2) MODBUS MAPPING TABLE
3) CHANGE RECORD OF QR CODE
Choose the HMI: 0=MASTER
15.5
17.3
P_X PORT
Select the function of P_X PORT:0=DEFORST,1=ALARM
0
/
STOP BIT
Upper computer stop bit:1=STOP BIT1,2=STOP BIT2
1
/