SYSVRF2 INDOOR UNIT OM
8
Adjust the louver to improve the cooling or heating effect.
■  Floor standing type
 Fig.4-11   
 Fig.4-16
● When heating
Adjust the louver downward (vertically). (Refer to Fig.4-14)
● When cooling 
Adjust the louver horizontally. (Refer to Fig.4-13)
Fig.4-13
Fig.4-14
Do not try to adjust the louver by hand, as doing so may 
cause a malfunction. 
CAUTION
 ■  Adjust the air direction left and right
 Fig.4-15
Before opening the front panel, cut off power supply and 
turn the breaker to OFF.
Do not touch the metal parts inside the indoor unit to avoid 
injury.
Open the front panel.
(How to open the front panel: refer to Fig.5-6).
CAUTION
 ■  Air flow selection
Table 4-1
Select the air flow as desired. 
When setting the air flow selection switch to ,
the air conditioner automatically decides the appropriate 
blowing pattern depending on the operating mode/ 
scenario.
In all modes, air is expelled from the upper air outlet.
Use this switch if you do not want air coming out of the 
lower air outlet (when sleeping).
Operating
mode
Situation
Blowing
pattern
cooling mode heating mode
When the room 
is cool or after 
running the air 
conditioner for 
one hour.
Air is blown via 
the upper air 
outlet to equalize 
the room 
temperature, so 
the air doesn’t 
directly blow 
onto people.
At the start 
of the 
operation 
or at other 
times when 
the room is 
not fully cooled.
At times other than those 
below. (Normal time.)
Air is blown from the 
upper and lower air 
outlets for 
high-speed cooling 
in cooling mode and 
for warming the air 
in heating mode.
At the start or 
when air 
temperature is 
low.
Air is blown via 
the upper air 
outlet, so it 
doesn’t directly 
blow onto 
people.
When setting the air outlet selection switch to .
To switch between Auto and Manual mode on the lower air 
outlet, turn off the unit and restart it to reset the modes.
CAUTION
■  Two-way cassette type
● Auto-swing
Press SWING and the louver will swing up and down automatical-
ly.
Fig.4-17
To change the air direction to the left or right, adjust the left and 
right louvers to appropriate positions. 










