IMO EX E

133285 / 8118609300
2015-03-24·BA00·III·en·05
Commissioning
11
Terminal Boxes
Series 8118/1, 8118/2
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
8 Commissioning
Before commissioning, ensure the following:
• Check the mounting and installation.
• Inspect enclosure for damage.
• If necessary, remove foreign bodies.
• If necessary, clean the connection chamber.
• Check whether the cables have been inserted correctly.
• Check if all screws and nuts have been tightened firmly.
• Check whether all the cable entries and stopping plugs have been tightened firmly.
• Check whether all conductors have been clamped firmly.
• Check whether all covers and partitions for live parts have been installed and fastened.
• Seal unused cable entries using plugs with a respective certification and unused holes
with stopping plugs certified for the respective type of protection.
• Check the tightening torques.
9 Maintenance, Overhaul and Repair
The following details must be checked during maintenance:
- Cables are held securely in place
- Compliance with the permissible temperatures (according to IEC/EN 60079)
- Damage to the enclosure and seals
- Check if screws and nuts are tight.
10 Cleaning
• Clean the device only with a damp cloth.
• When cleaning with a damp cloth, use water or mild, non-abrasive, non-scratching
cleaning agents.
• Do not use aggressive detergents or solvents.
WARNING
Check the device before commissioning!
To ensure the correct operation, check the device before commissioning.
WARNING
Close the enclosure according to regulations!
Use the device only if it is closed.
WARNING
Check the device at regular intervals!
To ensure the correct operation, check the device at regular intervals.
The inspections must be carried out according to the national regulations or
IEC 60079-17.
WARNING
Risk of electric shock!
Before opening the device, disconnect it from the power supply.